DRM-40 - Micro-ohmmeter for resistance from 0.01 micro ohm to 200 ohms

The DRM-40 micro-ohmmeter can be used to measure very low resistances which vary from 0,01 micro ohm to 200 ohms. This is the most accurate and competitive on the market in its category. It is used for quality control of smelting parts, control of mechanical joints, electrical connections, for inspection of contacts, circuit breakers, power fuses and more.

Application example

Quality control of the ground settings and power bars

The ground settings, which the teams of network technicians use in off-tension work, are their main guarantee of protection. It is of utmost importance for the manufacturers as well as for the users that the quality of these ground settings be checked on a regular basis. With its relative measurement mode, the DRM-40 takes a measurement on a standard ground setting and compares it to those obtained on other ground settings in order to verify if the deviation observed between the two measurements is acceptable or not. Its precision, within one hundredth of a micro ohm, is ten times superior to other instruments on the market.

Other applications

  • Quality control of smelting parts
  • Control of mechanical joints and of joints welded at high voltage
  • Control of exothermic joints (Cadweld®)
  • Control of electrodes for aluminum plants
  • Inspection of contacts, circuit breakers and power fuses

Advantages of the DRM-40

  • Much lighter and handier than other equipment in its category
  • Shock resistant, it is suitable for all types of applications: work site or laboratory
  • Its back-lighting liquid crystal display (LCD) enables it to be used in dark areas
  • Weak current injection for applications that require small measurement contacts
  • A variety of probes adapted to types of specific measurements such as the -inspection of exothermal welds. (Cadweld®), are available as options

Operation

The DRM-40 uses a four-pin resistance measurement system, which consists of injecting a current with two cables connected at each end of the joint to be tested. Then, the cables are installed which allow reading the tension on each side of the part to be tested in order to measure the resistance. This eliminates any uncertainty linked to resistance of the contacts. The instrument is equipped with a microprocessor, which eliminates gaps and parasite voltages. Thanks to its unique filtering system, the DRM-40 can be used in spite of the presence of intense magnetic fields.

Distributors

Web site designed by SYN Média inc.